DB Asset Services began as a company that is primarily engaged in condition monitoring. However, this is not only the case anymore. Our service package has developed over the years with the most varied techniques so that we are the ideal partner for your Asset Management.
In the menu above you can find the services we offer.
In order to get a good idea of the condition of your installation, we can perform different measurements. In this way, we act as a 'one stop shop' for your asset management.
This approach can be a great advantage for your organization.
When problems occur it is often not entirely clear what the cause is.
In (almost) all cases we are able to determine the cause of the failure of your installation, by combining our different measurement-tecniques.
Schotdeuren 47, 4241 BP
Arkel, The Netherlands
Tel: +31 (0)18 385 0946
In torque measurements, the torque is measured in the shaft of a drive. By measuring the strain in the surface of the shaft, the torque can be calculated on the shaft. This method of measurement is used, inter alia, in determining whether an installation is complying with the calculated power.
Electrical corrosion (discharge) is a common form of premature failure of a bearing. It is seen in many electric motors with modern inverters and frequency drives. These might provide high peak voltage across the bearing currents, which can cause damage.
The best time to start condition monitoring is in the factory, with a so called Factory Acceptance Test. As an independent company, DB Asset Services can perform these tests. It examines whether the new system meets the required standards.
If you cannot find what you need on our website, please contact our office. We are continually expanding our knowledge and services. Some of the technologies used by our mechanics are not listed on the website.